This option gives you a report showing the assemblies, the list of component parts, and the value (usually at cost price) for each of the component details and the assembly in total.
To accept the default details and print the report for all assemblies then you can select the PRINT button. Alternatively you can amend selected details of the report as explained below. When you select the PRINT option you are prompted to confirm the printer the report is to be output to and the report is then sent to the printer.
The OPTIONS button allows you to configure the paper size, font and margins of the printed report.The facilities available here are discussed in the Stock Reports section later.
The ‘From’ and ‘To’ prompts allow you to specify the range of assemblies printed.
Stock Assemblies are normally valued at cost price but you can amend the price this report is to be run using.
If you wish to restrict the assembly details displayed by means other than an assembly number range (perhaps a specific assembly stock code) then you can set this option and enter the criteria.
If a Stock Assembly contains a component that is a sub-assembly then this prompt asks whether the sub-assembly components are to be printed as part of the main assembly.Note that the ‘sub-assembly’ continues to be printed as an assembly in its own right.
If you wish to include any build instructions entered as comments or notes then set this option as required. These components are zero-value entries so have no effect on the value of the assembly.
Article ID: 440
Created On: Mon, Jun 18, 2012 at 2:09 PM
Last Updated On: Thu, Jun 22, 2023 at 11:16 PM
Online URL: https://kb.datafile.co.uk/article/print-value-assemblies-stock-control-440.html